The Prusa Mk3s+ printed it prefect first time. I suspect because it had a Gear Motor (thus had the extrusion tuned for the motor)
https://www.printedsolid.com/products/ldo-nema-17-geared-extruder-motor-ldo-42sth25-1004acpg3
The Bear Mk3s+ failed on .1, I assume because of slight over extrusion. Changed the extrusion multiple by 2% and it passed (on PETG..)
M92 E276
M500
The Voron failed even after extrusion correction.
top is Prusa, bottom is voron.
The following is after shaping and small chamber fan. The voron passed except for the "handle" looks ugly (its a long 80 degree overhang).
Voron passed with cheap ABS+ after using Ellis's settings
https://github.com/AndrewEllis93/Ellis-SuperSlicer-Profiles
and
https://ellis3dp.com/Print-Tuning-Guide/
he has profiles. You have to pull them into prusa
slicer, then you can compare. (basically you pull in the
.ini, it messes everything up, but you kinda rebuild it
and I think its good).
I had to discard all but filament profile.
No comments:
Post a Comment